A Rare, and Most Attractive Early Model Antique Smith & Wesson Mahoghany Cased .38 Cal. Double Action 5 Shot Revolver. Rare Three Figure Serial Number Circa 1880

Blued finish, original S & W hardened rubber grips, square back trigger guard, with 31/4 inch barrel. Tip up barrel with T section release lever catch and automatic cartridge ejector. Green baize lined case interior, polished mahogany wood case with single lidded tool receptacle. Fully functioning action and deactivated to UK spec. with certificate

Smith & Wesson was well positioned at the start of the American Civil War to provide additional revolvers (generally bought by individuals as additional firepower) to both sides of the conflict, with orders outpacing production. After the end of the American Civil War, Smith & Wesson turned from smaller pocket revolvers favored during the war years to larger framed models designed for open use with the expansion into the American West. In 1870, the Smith & Wesson Model 3 was released becoming the Schofield revolver as it was adopted by the U.S. Army chambered in .44 S&W (later in .45 S&W). The Model 3 became the first cartridge-firing handgun adopted by the U.S. Army.

The same revolver was also adopted by the Russian Empire in .44 Russian. This popular top-break single-action revolver remained in production into the early 20th century. 1880 saw the release of the first double-action revolver by Smith and Wesson (the 38 DA). With the popularity of double-action revolvers,

1st Model. Manufactured in 1880, with serial numbers from 1 to about 4,000. (The ending serial number is approximate; the exact transition number from 1st to 2nd model is unknown.) Features a straight-sided sideplate, a rocker-type cylinder stop, short cylinder flutes with double stop notches and free cuts on the cylinder, a reverse-curved trigger-guard bow, and a front sight pinned in place. It came in both 3-1/4- and 4-inch barrel lengths.

2nd Model. Manufactured from 1880 to 1884, with serial numbers from about 4,001 to approximately 119,000. (Again, the exact transition number to the 3rd Model is unknown.) Features an irregularly shaped sideplate, a rocker-type cylinder stop, short cylinder flutes with double stop notches and free cuts on the cylinder, a reverse-curved trigger-guard bow, and a front sight pinned in place. It was produced in 3-1/4-, 4-, 5-, and 6-inch barrel lengths.

This revolver is serial numbered within the first 200 manufactured in 1880.

Photo 9 in the gallery shows the interior with small tool section covered lid removed, revealing a turnscrew and barrel cleaning brush, and six dummy rounds set within the spare bullet retainer.

Deactivated with UK certificate, not suitable to export.

Code: 25696